“Since 1978, Our mission has been to provide our customers with the highest level of integrity and professional service with affordable pricing.”
 
David “Mr. Leak” Elbaum
N.J. Lic. No. 9259
FloodSafe
 

Tel:  201-265-0292

Fax: 201-265-0186

Email: info@mrleak.com

mrleak1@hotmail.com

Find a Plumber:
www.findaplumber.com


The Floodsafe™ Water Detector Shutoff protects the home or business owner
from catastrophic damage due to a water heater leak. The Floodsafe™ Water
Detector Shutoff detects the presence of water on the floor beneath the water
heater and automatically shuts off the water supply and the power source to
the water heater.

Features:

  • Testable and Resettable: This is NOT a one-time use device. The FloodSafe™ Water Detector Shutoff can be easily reset by the contractor, home or business owner or plumbing inspector to assure proper operation.
  • Easily installed on new or existing water heaters.
    – No special piping is required.
    – Supplied with a Water Dam for concrete, linoleum, tile or other hard surface fl ooring.
    – Sized for 3⁄4" or 1" water supply lines.
    – Secure interlocking connector cables are unique to each connecting device.
    – Powered by a safe low-voltage Power Supply that plugs into a standard 120 VAC wall outlet and is wired using standard thermostat cable.
    – No electrician required for gas and oil installations.
  • Employs state-of-the-art water detection technology (no
    terminals to corrode or impair operation).
  • Provides contacts for monitored alarm detection systems.
  • Power Cutout Modules for the standing pilot gas fi red water heaters retain thermocouple circuit in the event of momentary power outage.

How It Works

  • The Control Unit, which houses the circuitry, alarm lamp, audible alarm, alarm silence button, and
    connector sockets, is installed on the cold water supply to the water heater.
  • The exclusive Water Detector Pad lays flat on the floor (or in a water heater drip pan).
  • Upon detection of as little as 1⁄16" of standing water the
    Control Unit initiates the alarm and shutoff sequence.
  1. Shuts off the water supply to the water heater. Closes the cold water supply to the water heater to minimize water leakage and water damage.
  2. Removes the source of power to the water heater. Should the cause of water detection be from the temperature and pressure safety relief valve discharge, it is important that the supply of energy to the water heater be removed to protect against an extremely hazardous condition or explosion. Protects your home or business against the danger of explosion.
  3. Energizes an audible alarm and remote alarm contacts. The Floodsafe™ Water Detector Shutoff has an internal alarm to alert the homeowner. It also has contacts that can be connected to a monitored alarm system, to provide 24/7 notification to a home or business security service.

 

 
                                       
MrLeak.Com© 2006 | All Rights Reserved
Site Developed and Maintained by Netconnections.org  
  Home | About Us | Services | Site Map | FloodSafe | Contact Us